Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISGENERAL INFORMATIONOBD-II DRIVE CYCLESDRIVE CYCLES2001: MILLENIAEVAP MONITOR REPAIR VERIFICATION DRIVE MODE
2010 Mazda 5 Sport, 2.3 L, Standard
EVAP Monitor Repair Verification Drive Mode
2010 Mazda 5 Sport, 2.3 L, StandardSECTION EVAP Monitor Repair Verification Drive Mode
NOTE:
If EVAP monitor repair verification drive mode cannot be performed because vehicle cannot be driven during conditions specified for this test, perform evaporative system test procedure as an alternative. See SYSTEM & COMPONENT TESTING - MIATA, MILLENIA, MPV, PROTEGE & 626 article.
- Ensure following conditions are met:
- Engine coolant temperature is 14°F (-10°C).
- Intake air temperature is 14-131°F (-10-55°C).
- Barometric pressure is 72 kPa.
- Fuel Tank Level (FTL) PID V data is .5-2.5 volts.
- Ensure all accessories are off.
- Start and operate engine at 3500 RPM to warm to normal operating temperature. Operate vehicle as specified. SeeFig 1. Stop vehicle and access ON BOARD SYSTEM READINESS menu of GENERIC OBD II FUNCTIONS to check drive mode completion status. RFC should change to YES when test is complete. If test is not complete, turn ignition off and repeat this step. If test is complete, go to next step.
- Check test results in DIAGNOSTIC MONITORING TEST RESULTS menu of GENERIC OBD II FUNCTIONS. If results are okay (MEAS value of 10:21:00 and 10:22:00 are within specification), ensure no DTCs are present. If no DTCs are present, repairs are complete. If results are not okay (MEAS value of 10:21:00 and 10:22:00 are not within specification), repairs are not complete.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.