Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Preliminary Check
Turn ignition on. Turn defogger switch to ON position. If glass is not warm after a few minutes, check fuses. See WIRING DIAGRAMS . If fuses are okay, check for battery voltage at grid feed wire. If battery voltage is present, check grid filament for good ground or breaks in grid wire filaments. Repair circuit(s) as necessary. See THE DEFROST SYSTEM IS INOPERATIVE (PINPOINT TEST 6) as necessary
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.