Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 585 (ENTERTAINMENT SYSTEM)REAR SPEAKER REMOVAL/INSTALLATION

2010 Mazda 5 Sport, 2.3 L, Standard

Rear Speaker Removal/Installation

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Rear Speaker Removal/Installation

WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the following parts:
1. Rear package tray lid (See REAR PACKAGE TRAY LID REMOVAL/INSTALLATION .)
2. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
3. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
4. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
5. Lower anchor of the third-row seat belt (See THIRD-ROW SEAT BELT REMOVAL/INSTALLATION .)
6. Cargo compartment light (See CARGO COMPARTMENT LIGHT REMOVAL/INSTALLATION .)
7. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
Remove in the order indicated in the table.

Fig 1: Identifying Rear Speaker Remove/Install Components
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.