Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 582 (LIGHTING SYSTEM)REAR COMBINATION LIGHT REMOVAL/INSTALLATIONNOTES

2010 Mazda 5 Sport, 2.3 L, Standard

Rear Combination Light Removal/Installation: Notes

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Notes

WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.

Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] ).
Disconnect the negative battery cable.
Remove the following parts:
1. Rear package tray lid (See REAR PACKAGE TRAY LID REMOVAL/INSTALLATION ).
2. Sub-trunk
3. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION ).
4. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION ).
5. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION ).
6. Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT REMOVAL/INSTALLATION ).
7. Cargo compartment light (See CARGO COMPARTMENT LIGHT REMOVAL/INSTALLATION ).
8. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION ).
Remove in the order indicated in the table. LED type

Fig 1: Identifying Rear Combination Light Remove / Install Components (Led Type)
Courtesy of MAZDA MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.