Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 574 (WASHER SYSTEM & WIPER SYSTEM)WINDSHIELD WIPER MOTOR INSPECTION
2010 Mazda 5 Sport, 2.3 L, Standard
Windshield Wiper Motor Inspection
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Windshield Wiper Motor Inspection
WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the windshield wiper motor connector.
- Connect battery positive voltage to windshield wiper motor terminal A or B, and ground to terminal D, then verify that the windshield wipers operate as shown in the table.
- If the windshield wipers do not operate as indicated in the table, replace the windshield wiper motor.
WINDSHIELD WIPER MOTOR OPERATION REFERENCETerminal connected to battery positive voltage Operation condition A LO B HI - Disconnect battery positive voltage from the motor terminal A while the wipers are operating.
- Verify that the wipers do not stop in the park position.
- Short between the motor terminals A and C, and connect battery positive voltage to the motor terminal E.
- Verify that the wipers operate at low speed again, then stop in the park position.
- If there is any malfunction, replace the windshield wiper motor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.