Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 574 (WASHER SYSTEM & WIPER SYSTEM)WINDSHIELD WIPER MOTOR DISASSEMBLY/ASSEMBLYWINDSHIELD WIPER MOTOR ASSEMBLY NOTE
2010 Mazda 5 Sport, 2.3 L, Standard
Windshield Wiper Motor Assembly Note
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Windshield Wiper Motor Assembly Note
WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the windshield wiper motor to the vehicle wiring harness connector, operate the windshield wipers, and then stop them at the auto-stop position.
- Adjust the motor crank, wiper link No.1, and wiper link No.2 so that they are parallel as shown in the figure.
- Assemble the windshield wiper motor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.