DTC P0117 [L3]: Notes

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Notes
WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0117 [L3] DETECTION CONDITIONS AND POSSIBLE CAUSES

DTC P0117 ECT sensor circuit low input
DETECTION CONDITION 
  • The PCM monitors the ECT sensor signal at PCM terminal 2AH. If the PCM detects the ECT sensor voltage below 0.2 V  for 5 s  , the PCM determines that the ECT sensor circuit has malfunction.

Diagnostic support note 
  • This is a continuous monitor (Engine cooling system).
  • MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • ECT sensor malfunction
  • Connect or terminal malfunction
  • Short to ground in wiring harness between ECT sensor terminal A and PCM connector terminal 2AH
  • Short each wiring harness ECT signal circuit and ECT ground circuit
  • PCM malfunction
G05542951
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.