SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 548 (CONTROL SYSTEM (HVAC))CONTROL SYSTEM [FULL-AUTO AIR CONDITIONER]SOLAR RADIATION SENSOR REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER]
2010 Mazda 5 Sport, 2.3 L, Standard

Solar Radiation Sensor Removal/Installation [Full-Auto Air Conditioner]

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Solar Radiation Sensor Removal/Installation [Full-Auto Air Conditioner]
WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Pry the solar radiation sensor from the dashboard using a flathead screwdriver wrapped with protective tape.
  3. Remove in the order indicated in the table.
    CAUTION:
    • After the solar radiation sensor removal, the sensor connector could fall in the dashboard making the installation difficult. Therefore, hold the rooted end of the sensor connector using a clip or similar tool to prevent it from falling.
      Fig 1: Identifying Solar Radiation Sensor And Connector
      G05543348Courtesy of MAZDA MOTORS CORP.
  4. Install in the reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.