Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 535 (INTERIOR TRIM)
2010 Mazda 5 Sport, 2.3 L, Standard
Section 535 (Interior Trim)
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Section 535 (Interior Trim)
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Dashboard Removal/Installation
- Dashboard Disassembly/Assembly
- Center Panel Removal/Installation
- Column Cover Removal/Installation
- Console Removal/Installation
- Console Disassembly/Assembly
- Glove Compartment Removal/Installation
- Lower Panel Removal/Installation
- Meter Hood Removal/Installation
- Door Trim Removal/Installation
- A-Pillar Trim Removal/Installation
- Front Header Trim Removal/Installation
- Quarter Trim Removal/Installation
- Rear Package Trim Removal/Installation
- Scuff Plate Removal/Installation
- Front Side Trim Removal/Installation
- Trunk End Trim Removal/Installation
- Trunk Side Trim Removal/Installation
- Top Trim Removal/Installation
- Floor Covering Removal/Installation
- Rear End Mat Removal/Installation
- AEROBOARD Removal/Installation
- AEROBOARD Disassembly/Assembly
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.