Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 503 (ENGINE CONTROL SYSTEM)POWER STEERING PRESSURE (PSP) SWITCH INSPECTIONINSPECTION OF CONTINUITY
2010 Mazda 5 Sport, 2.3 L, Standard
Inspection of Continuity
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Inspection of Continuity
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Perform the following test only when directed.
- Inspect as follows if power steering is inoperative:
- POWER STEERING FLUID INSPECTION (See POWER STEERING FLUID INSPECTION )
- Disconnect the PSP switch connector.
- Start the engine.
- Inspect for continuity between PSP switch terminal and GND using an ohmmeter.
- If not as specified, replace the PSP switch.
- If PSP switch is okay but PID value is out of specification, perform the CIRCUIT OPEN/SHORT INSPECTION .
Specification
- Reconnect the PSP switch connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.