SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 503 (ENGINE CONTROL SYSTEM)CLUTCH PEDAL POSITION SWITCH INSPECTIONINSPECTION OF CONTINUITY
2010 Mazda 5 Sport, 2.3 L, Standard

Inspection of Continuity

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Inspection of Continuity
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Perform the following test only when directed.
  1. Verify that the clutch pedal position switch is installed properly. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
  2. Disconnect the negative battery cable.
  3. Remove the clutch pedal position switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
  4. Inspect continuity between the clutch pedal position switch terminals using an ohmmeter.
    • If not as specified, replace the clutch pedal position switch.
    • If clutch pedal position switch is okay, but PID value is out of specification, perform the CIRCUIT OPEN/SHORT INSPECTION .

    Specification 

    Fig 1: Identifying Clutch Pedal Position Switch Terminal Continuity
    G03638017Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.