Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 501 (STARTING SYSTEM)STARTER REMOVAL/INSTALLATIONSTARTER INSTALLATION NOTE
2010 Mazda 5 Sport, 2.3 L, Standard
Starter Installation Note
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Starter Installation Note
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Temporarily tighten the starter fitting bolt A.
- Tighten the starter fitting bolts B and C.
Tightening torque
38-51 N. m {3. 8-5. 3 kgf. m, 28-38 ft. lbf}
- Tighten the starter fitting bolt A.
Tightening torque
38-51 N. m {3. 8-5. 3 kgf. m, 28-38 ft. lbf}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.