SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 46 (ENGINE CONTROLS - SELF-DIAGNOSTICS)DIAGNOSTIC TESTSDTC P1450: EVAP MONITORDETECTION CONDITION
2010 Mazda 5 Sport, 2.3 L, Standard

Detection Condition

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Detection Condition
WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.

DTC P1450 indicates self-test has detected the EVAP system is unable to bleed up fuel tank vacuum. EVAP canister purge valve is normally closed. It controls the flow of vapors (purging) from EVAP canister to intake manifold during various engine operating modes.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.