Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 416 (CONTROL SYSTEM (HVAC))REFRIGERANT PRESSURE SWITCH INSPECTION
2010 Mazda 5 Sport, 2.3 L, Standard
Refrigerant Pressure Switch Inspection
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Refrigerant Pressure Switch Inspection
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- Install the manifold gauge set. (See MANIFOLD GAUGE SET INSTALLATION .)
- Disconnect the refrigerant pressure switch connector.
- Verify the high-pressure side reading of the manifold gauge and continuity between the terminals B and C, and A and D is as shown.
- If there is any malfunction, replace the front cooler pipe No.2.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.