Selector Lever Removal/Installation: Notes

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Notes
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read AIR BAG SYSTEM SERVICE WARNINGS before handling the air bag module. (See SERVICE WARNINGS .)
  1. Disconnect the negative battery cable.
  2. Remove in the order indicated in the table.
    Fig 1: Removing Selector Lever Components - With Torque Specifications
    G03700617Courtesy of MAZDA MOTORS CORP.
  3. Install in the reverse order of removal.
  4. Inspect the shift-lock. (See SHIFT-LOCK INSPECTIONΒ .)
  5. Inspect the shift-lock release lever. (See SHIFT-LOCK RELEASE LEVER INSPECTIONΒ .)
  6. Inspect the key interlock system. (See KEY INTERLOCK INSPECTIONΒ ).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.