SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 395 (FUEL SYSTEM)FUEL TANK INSPECTIONOBD II REGULATION VEHICLE
2010 Mazda 5 Sport, 2.3 L, Standard

OBD II Regulation Vehicle

2010 Mazda 5 Sport, 2.3 L, StandardSECTION OBD II Regulation Vehicle
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This inspection is for fuel shut-off valve and two rollover valves integrated in the fuel tank.
  1. Disconnect the plastic fuel hose and the fuel pump unit connector. (See FUEL PUMP UNIT REMOVAL/INSTALLATION .)
  2. Remove the fuel tank with the fuel pump unit. (See FUEL TANK REMOVAL/INSTALLATION .)
  3. Plug the fuel main pipe of the fuel pump unit.
  4. Plug port C.
  5. Level the fuel tank.
    Fig 1: Identifying Fuel Pump Unit Components (OBD II Regulation Vehicle) (1 Of 2)
    G03699869Courtesy of MAZDA MOTORS CORP.
  6. Blow through port B and verify that there is airflow from port A.
    • If there is no airflow, replace the fuel tank.
    • If there is airflow, turn the fuel tank upside-down, and proceed to next step.
  7. Blow through port B and verify that there is no airflow from port A.
    • If there is airflow, replace the fuel tank.
    Fig 2: Identifying Fuel Pump Unit Components (OBD II Regulation Vehicle) (2 Of 2)
    G03699870Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.