SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 353 (FRONT SUSPENSION SYSTEM)FRONT UPPER ARM REMOVAL/INSTALLATIONBOLT (FRONT UPPER ARM) REMOVAL NOTE
2010 Mazda 5 Sport, 2.3 L, Standard

Bolt (Front Upper Arm) Removal Note

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Bolt (Front Upper Arm) Removal Note
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the nuts (3 locations) from the upper part of the front shock absorber.
  2. Pull the front shock absorber and coil spring out of the way, towards the outer side of the vehicle.
    Fig 1: Pulling Front Shock Absorber And Coil Spring Out Of The Way
    G03644279Courtesy of MAZDA MOTORS CORP.
  3. Remove the bolts.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.