Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 353 (FRONT SUSPENSION SYSTEM)FRONT LOWER ARM (FRONT) INSPECTION
2010 Mazda 5 Sport, 2.3 L, Standard
Front Lower Arm (Front) Inspection
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Front Lower Arm (Front) Inspection
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the lower arm (front) from the vehicle.
- Inspect for damage, cracks, and bending.
- Inspect the ball joint rotational torque.
- Rotate the ball joint five times.
- Measure the rotational torque using a suitable allen socket and a torque wrench.
- If not within the specification, replace the lower arm component.
Rotation torque 1.18-2.23 N.m {12.1-22.7 kgf.cm, 10.5-19.7 in.lbf}
- If not within the specification, replace the lower arm component.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.