Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 349 (ENGINE CONTROL SYSTEM (L3))KNOCK SENSOR (KS) REMOVAL/INSTALLATION
2010 Mazda 5 Sport, 2.3 L, Standard
Knock Sensor (KS) Removal/Installation
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Knock Sensor (KS) Removal/Installation
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the intake manifold. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
- Remove the KS attachment bolt to remove the KS.
- Install in the reverse order of removal.
Tightening torque 16.2-23.8 N.m
{1.66-2.42 kgf.m, 12.0-17.5 ft.lbf}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.