Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 308 (SECURITY SYSTEM AND LOCKS SYSTEM)LIFTGATE LATCH REMOTE CONTROLREMOVAL AND INSTALLATION

2010 Mazda 5 Sport, 2.3 L, Standard

Removal and Installation

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Removal and Installation

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Remove the liftgate trim panel.

Fig 1: Disconnecting Liftgate Latch Remote Control Actuating Rods
Courtesy of MAZDA MOTORS CORP.
Disconnect the liftgate latch remote control actuating rods.
1. Open the clip and disconnect the liftgate window latch actuating rod.
2. Open the clip and disconnect the liftgate latch actuating rod.
  
  Fig 2: Disconnecting Electrical Connectors
  Courtesy of MAZDA MOTORS CORP.
Disconnect the electrical connectors.
1. If equipped, disconnect the liftgate latch actuator electrical connector.
2. Release the liftgate window latch ajar switch wiring harness locator.
  
  Fig 3: Removing Liftgate Latch Remote Control Assembly
  Courtesy of MAZDA MOTORS CORP.
Remove the liftgate latch remote control assembly.
- Remove the screw.
- Remove the nuts.
To install, reverse the removal procedure.
- Transfer all necessary components.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.