SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 297 (BASIC SYSTEM (HVAC))CLIMATE CONTROL SYSTEMFLOOR
2010 Mazda 5 Sport, 2.3 L, Standard

Climate Control System: Floor

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Floor
WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Air Flow Direction (Floor Selected)
G01902489Courtesy of MAZDA MOTORS CORP.

When FLOOR is selected:

  • The air inlet blend door is in the no vacuum position, blocking recirculation air and allowing outside air.
  • The footwell airflow door is at the full vacuum position, opening the door and allowing airflow through the footwell ducts.
  • The defrost airflow door and the vent/register blend door are in the no vacuum position, closing off airflow to the windshield defroster hose nozzles and driver, passenger and center registers.
  • The temperature control can be positioned to mix air flowing through and around the heater core to achieve the selected temperature level.
  • The A/C compressor is disabled when FLOOR is selected.
  • The blower motor is on.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.