Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 219 (WHEEL ALIGNMENT)FRONT WHEEL ALIGNMENTTOTAL TOE-IN ADJUSTMENT
2010 Mazda 5 Sport, 2.3 L, Standard
Total Toe-in Adjustment
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Total Toe-in Adjustment
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the locknut of the tie-rod end.
- Remove the rack boot clamp.
- Adjust the total toe-in by rotating each tie rod (left and right) in the opposite directions by the same amount respectively.
Total Toe-in Standard
2+/-4 mm {0.08+/-0.15 in} (0°11`+/-21`)
NOTE:- Toe angle changes byapprox. 5 mm {0.2 in} per one rotation of the tie rod for one wheel.
- Each tie rod has a left-hand thread. When increasing the toe-in angle, rotate the right tie rod toward the rear of the vehicle, and rotate the left tie rod toward the front of the vehicle by the same amount.
- Tighten the locknut of the tie-rod end.
Tightening Torque
37.0-49.0 N.m {3.78-4.99 kgf.m, 27.3-36.1 ft.lb}
- Verify that the rack boot does not have any twisting, and install the rack boot clamp.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.