Front Fog Light Removal/Installation

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Front Fog Light Removal/Installation
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the mud guard.
  3. Remove in the order indicated in the appropriate table/figure.
    Fig 1: Removing/Installing Front Fog Light - Standard
    G02564049Courtesy of MAZDA MOTORS CORP.
    REMOVING/INSTALLING FRONT FOG LIGHT - SPORTS (1)

    Component/Step No. Component Description
    1 Connector
    2 Screw
    3 Screw
    4 Bolt (Sports)
    5 Bracket (Standard)
    6 Front Fog Light Cover (Sports)
    7 Front Fog Light
    (1) See Fig 2.
    Fig 2: Removing/Installing Front Fog Light - Sports
    G02564050Courtesy of MAZDA MOTORS CORP.
  4. Install in the reverse order of removal.
  5. Adjust the front fog light aiming. (See FRONT FOG LIGHT ADJUSTMENTΒ .)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.