Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 184 (HVAC SYSTEM)CONTROL SYSTEMTHERMOSENSOR INSPECTIONTO DETERMINE IF THE SENSOR IS FUNCTIONING
2010 Mazda 5 Sport, 2.3 L, Standard
To Determine If The Sensor is Functioning
2010 Mazda 5 Sport, 2.3 L, StandardSECTION To Determine If The Sensor is Functioning
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- Start the engine.
- Turn the A/C switch on.
- Turn the front fan switch on.
- Connect the positive (+) and negative (-) probes of the tester to terminal A and terminal C of the thermosensor respectively. (The wiring harness connector must be connected to the thermosensor connector.)
- Inspect the voltage as shown below.
- If there is any malfunction, inspect on/off points of the thermosensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.