SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 140 (ANTI-LOCK/TRACTION CONTROL SYSTEM)SENSOR - REARREMOVAL & INSTALLATION
2010 Mazda 5 Sport, 2.3 L, Standard

Removal & Installation

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Removal & Installation
WARNING: This page is about a different car, the 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. Refer to WHEELS AND TIRES .
  2. Detach the grommet from the body and pull the connector through the hole.
    Fig 1: Remove Grommet
    G01150477Courtesy of MAZDA MOTORS CORP.
  3. Disconnect the sensor wiring.
    Fig 2: Disconnecting Sensor Wiring
    G01150478Courtesy of MAZDA MOTORS CORP.
  4. Detach the bolt.
    Fig 3: Disconnecting Sensor Wiring Retainer Bolt
    G01150479Courtesy of MAZDA MOTORS CORP.
  5. Remove the bolts.
    Fig 4: Removing Sensor Wiring Retainer Bolts
    G01150480Courtesy of MAZDA MOTORS CORP.
    6. NOTE: Clean off any dirt that may have collected around the sensor before removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.