Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1 (ENGINE CONTROLS - SYSTEM & COMPONENT TESTING)IDLE CONTROL SYSTEMSYSTEM CHECK - MPV
2010 Mazda 5 Sport, 2.3 L, Standard
System Check - MPV
2010 Mazda 5 Sport, 2.3 L, StandardSECTION System Check - MPV
WARNING: This page is about a different car, the 2001 Mazda Protege, 2001 Mazda Millenia, 2001 Mazda MX-5 Miata, 2001 Mazda MPV, and 2001 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure engine is at ambient temperature. Connect scan tool. Using PID/DATA monitor and record function, select ECT, IAC V and RPM PIDs. Start engine.
- Engine speed should decrease as engine reaches operating temperature. If idle speed decreases, go to next step. If engine speed does not decrease, check ECT sensor, IAC valve and wiring.
- Allow engine to warm to operating temperature. Check for DTC P0506, P0507 and P1504. If no DTCs are present, go to next step. If any DTCs are present, diagnose and repair as necessary.
- Using scan tool, select SIMULATION TEST. Change duty value of IAC valve to 100 percent. If idle speed increases, go to next step. If idle speed does not increase, check IAC valve passages and wiring.
- Using scan tool PID/DATA monitor and record function, select A/C SW, ALTF, IAC V, PSP SW, RPM and RPM DES PIDs. Ensure idle speed stays in specification when accessories are operated. See IDLE SPECIFICATIONS table. If idle speed is okay, check is complete. If idle speed is not okay, check suspect component and circuit.
IDLE SPECIFICATIONS
| Condition | (1) Idle Speed | ||||
|---|---|---|---|---|---|
| No Load | 700-800 | ||||
| All Accessories On (2) | 700-800 | ||||
| Power Steering Operating | 700-800 | ||||
| A/C On | 800-900 | ||||
|
|||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.