DTC P2088: Notes

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Notes
DTC P2088 [L3] DETECTION CONDITIONS AND POSSIBLE CAUSES

DTC P2088 Oil control valve (OCV) circuit low
DETECTION CONDITION 
  • The PCM monitors the OCV voltage. If the PCM detects the OCV control voltage (calculated from the OCV) is below the threshold voltage (calculated from the battery positive voltage), the PCM determines that the OCV circuit has a malfunction.

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA (Mode 2/Mode12) is available.
  • DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Poor connection at the PCM or OCV connector
  • OCV malfunction
  • Open circuit in wiring between the main relay and OCV terminal B
  • Open circuit in wiring between OCV terminal A and PCM terminal 2E
  • Short to ground in wiring between OCV terminal A and PCM terminal 2E
  • PCM malfunction
G06760510Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.