Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSPOWER WINDOW MAIN SWITCH REMOVAL/INSTALLATION
2010 Mazda 5 Sport, 2.3 L, Standard
Power Window Main Switch Removal/Installation
2010 Mazda 5 Sport, 2.3 L, StandardSECTION Power Window Main Switch Removal/Installation
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3] .)
- Disconnect the negative battery cable.
- Remove the cover, then remove the screw.
- Detach clips B using a tape-wrapped Flathead screwdriver.
- Detach tab A by pulling it in the direction of the arrow in illustration, and remove the switch panel from the front door trim.
- Disconnect the power window main switch connector and the power outer mirror switch connector.
- Remove the screws, then remove the power window main switch.
- Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.