SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20105 SPORT, 2.3 L, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMAUTO LIGHT ILLUMINATION LEVEL SETTING
2010 Mazda 5 Sport, 2.3 L, Standard

Auto Light Illumination Level Setting

2010 Mazda 5 Sport, 2.3 L, StandardSECTION Auto Light Illumination Level Setting
  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Module Programming".
    • When using the PDS (Pocket PC)
      1. Select "Programming".
      2. Select "Module Programming".
  3. Then, select items from the screen menu in the following order.
    1. Select "Programmable Parameters".
    2. Select "Exterior Lighting".
      Fig 1: Identifying DLC-2 Connector
      G05545260Courtesy of MAZDA MOTORS CORP.
  4. Select the item name, and then select option.
    • Autolamp On Setting (Standard (other)/Low (other))
      NOTE:
      • When the M-MDS is set to Low, the auto-light sensor sensitivity decreases, and the TNS and headlight illumination timing is slower.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.