Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20103 MAZDASPEED, 2.3 4REPAIR AND DIAGNOSISBODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSFRONT POWER WINDOW REGULATOR REMOVAL/INSTALLATION

2010 Mazda 3 Mazdaspeed, 2.3 4

Front Power Window Regulator Removal/Installation

2010 Mazda 3 Mazdaspeed, 2.3 4SECTION Front Power Window Regulator Removal/Installation

To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}.
Disconnect the negative battery cable.
Remove the following parts:
1. Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
2. Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
3. Front door speaker (See FRONT DOOR SPEAKER REMOVAL/INSTALLATION .)
  
  Fig 1: Identifying Distance From Top Of Front Door Glass To Upper Part Of Front Beltline Molding Is Approx. 80 mm (3.1 in)
  Courtesy of MAZDA MOTORS CORP.
4. Front door glass (See FRONT DOOR GLASS REMOVAL/INSTALLATION .)
5. Front power window motor (See POWER WINDOW MOTOR REMOVAL/INSTALLATION .)
Remove the nuts.

Fig 2: Front Power Window Regulator And Nut With Torque Specifications
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.
CAUTION:
- When installing, do not allow the cable to come out from the drum housing.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.