Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transaxle Oil Replacement [A26M-R]
2010 Mazda 3 L4-2.5LSECTION Transaxle Oil Replacement [A26M-R]
TRANSAXLE OIL REPLACEMENT [A26M-R]
1. Park the vehicle on level ground.
2. Remove the aerodynamic under cover No.2. Aerodynamic Under Cover No.2 Removal/Installation
3. Remove the drain plug with the washer.
4. Drain the oil into a suitable container.
5. Install a new washer and the drain plug.
Tightening torque
- 28-50 Nm {2.9-5.1 kgf-m, 21-37 ft-lbf}
6. Remove the oil level plug with washer and add the specified amount and type of oil through the oil level plug hole until the level reaches the bottom of the oil level plug hole.
Manual transaxle oil grade
- API service GL-4
Manual transaxle oil viscosity
- SAE 75W-80
Manual transaxle oil capacity (approx. quantity)
- 2.4-2.6 L {2.6-2.7 US qt, 2.12-2.28 lmp qt}
7. Install a new washer and the oil level plug.
Tightening torque
- 28-50 Nm {2.9-5.1 kgf-m, 21-37 ft-lbf}
8. Install the aerodynamic under cover No.2. Aerodynamic Under Cover No.2 Removal/Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.