Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20103 L4-2.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSSERVICE AND REPAIR
2010 Mazda 3 L4-2.5L
Turn Signals: Service and Repair
2010 Mazda 3 L4-2.5LSECTION Service and Repair
FRONT COMBINATION LIGHT REMOVAL/INSTALLATION
WARNING:
- Incorrect servicing of the discharge headlights could result in electrical shock. Before servicing the discharge headlights, always refer to the discharge headlight service warnings. Service Precautions
1. Disconnect the negative battery cable.
2. Remove the front bumper. Front Bumper Removal/Installation
3. Remove the bolt and fastener shown in the figure.
4. Disconnect the connector.
5. Pull the front combination light in the direction of the arrow shown in the figure and remove the pin from the body.
6. Remove the front combination light.
7. Remove the bolts.
8. Pull the cover in the direction of the arrow (1) while detaching tab.
9. Remove the cover from the front combination light.
10. Install in the reverse order of removal.
11. Adjust the headlight aiming. Adjustments
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.