Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009TRIBUTE 4WD L4-2.5LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW GLASSLIFTGATE WINDOW GLASSSERVICE AND REPAIR
2009 Mazda Tribute 4WD L4-2.5L
Liftgate Window Glass: Service and Repair
2009 Mazda Tribute 4WD L4-2.5LSECTION Service and Repair
LIFTGATE GLASS REMOVAL/INSTALLATION
1. Open the liftgate glass.
2. Remove the 2 liftgate glass nut access covers.
3. Through the RH access, disconnect the liftgate glass electrical harness connector.
4. Disconnect the LH heated window grid wire electrical connector.
5. Disconnect the 2 liftgate glass cylinders.
a. Slide the spring retainer to the end of the socket.
b. Disconnect the socket from the ball stud.
NOTE:An assistant may be needed to carry out this step.
6. Remove the 2 liftgate glass hinge nuts and the liftgate glass.
- To install, tighten to 7 Nm {0.7 kgf-m, 62 in-lbf}.
NOTE:An assistant may be needed to carry out this step.
7. To install, reverse the removal procedure.
- Transfer components as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.