Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009TRIBUTE 4WD L4-2.5LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHSERVICE AND REPAIR
2009 Mazda Tribute 4WD L4-2.5L
Ignition Switch: Service and Repair
2009 Mazda Tribute 4WD L4-2.5LSECTION Service and Repair
IGNITION SWITCH REMOVAL/INSTALLATION
CAUTION:Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column can result.
1. Depower the supplemental restraint system (SRS). See Supplemental Restraint System (SRS) Depowering And Repowering.
2. Remove the steering column opening trim.
3. Remove the 3 lower steering column shroud screws.
4. Remove the upper and lower steering column shrouds.
5. Disconnect the ignition switch electrical connector.
6. Remove the ignition switch by pressing the 2 tabs and pulling the ignition switch outward.
7. To install, reverse the removal procedure. Repower the SRS. See Supplemental Restraint System (SRS) Depowering And Repowering.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.