Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009TRIBUTE 4WD L4-2.5LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVARIABLE VALVE TIMING SOLENOIDSERVICE AND REPAIR
2009 Mazda Tribute 4WD L4-2.5L
Variable Valve Timing Solenoid: Service and Repair
2009 Mazda Tribute 4WD L4-2.5LSECTION Service and Repair
-
VARIABLE CAMSHAFT TIMING (VCT) OIL CONTROL SOLENOID - 2.5L REMOVAL/INSTALLATION
1. Remove the valve cover. See - Service and Repair
2. Remove the bolt and the Variable Camshaft Timing (VCT) oil control solenoid.
- To install, tighten to 10 Nm {1.0 kgf-m, 89 in-lbf}.
3. To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.