Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009TRIBUTE 4WD L4-2.5LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONPINPOINT TESTSCAN COMMUNICATION NETWORKPINPOINT TEST 7: THE POWER STEERING CONTROL MODULE DOES NOT RESPOND TO THE SCAN TOOL
2009 Mazda Tribute 4WD L4-2.5L
Pinpoint Test 7: The Power Steering Control Module Does Not Respond To The Scan Tool
2009 Mazda Tribute 4WD L4-2.5LSECTION Pinpoint Test 7: The Power Steering Control Module Does Not Respond To The Scan Tool
PINPOINT TEST 7: THE POWER STEERING CONTROL MODULE (PSCM) DOES NOT RESPOND TO THE SCAN TOOL
Normal Operation
The power steering control module (PSCM) communicates with the scan tool through the high speed controller area network (HS-CAN). Circuits (W/L) (HS-CAN +) and (W) (HS-CAN -) provide the HS-CAN connection to the PSCM. The PSCM shares the HS-CAN with the PCM, the ABS module, the 4X4 control module, the instrument cluster (IC), the occupant classification sensor module (OCSM) and the restraints control module (RCM). Voltage for the PSCM is provided by circuit (Y/GY) and circuit (B/V) provides ground.
Possible Causes
- Fuse
- Wiring, terminals or connectors
- PSCM
Diagnostic Procedure
CAUTION:Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
NOTE:Failure to disconnect the battery when instructed will result in false resistance readings. See Battery Disconnect.
Step 1-Step 4:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.