Removal and Replacement

2009 Mazda CX-9 FWD V6-3.7LSECTION Removal and Replacement



REQUEST SWITCH REMOVAL/INSTALLATION [ADVANCED KEYLESS SYSTEM]

Driver Side/Passenger Side

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Inner garnish Inner Garnish Removal/Installation

b. Front door trim Front Door Trim Removal/Installation

c. Front door speaker Front Door Speaker Removal/Installation

d. Front door glass Service and Repair

e. Front door module Front Door Module Removal/Installation

3. Remove the screw A, then remove the handle seat.






4. Remove screw B, then remove the request switch.

Liftgate

1. Disconnect the negative battery cable.

2. Remove the liftgate upper trim.

3. Remove the liftgate side trim.

4. Remove the liftgate lower trim.

5. Remove the rear finisher.

6. Press the tabs and remove the request switch.

7. Install in the reverse order of removal.






RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.