Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009CX-9 FWD V6-3.7LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTCOLLISION AVOIDANCE AND PARKING ASSIST SYSTEMSSERVICE AND REPAIR
2009 Mazda CX-9 FWD V6-3.7L
Collision Avoidance and Parking Assist Systems: Service and Repair
2009 Mazda CX-9 FWD V6-3.7LSECTION Service and Repair
BLIND SPOT MONITORING (BSM) BRACKET REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the rear combination light. Rear Combination Light Removal/Installation
3. Remove the rear bumper. Removal and Replacement
4. Remove the BSM control module. Service and Repair
5. Remove the nuts.
6. Remove the BSM bracket.
7. Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.