Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2009B2300 L4-2.3LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSFLEX PLATE
2009 Mazda B2300 L4-2.3L
Flex Plate
2009 Mazda B2300 L4-2.3LSECTION Flex Plate
Tighten the bolts in the sequence shown in three stages.
Stage 1: Tighten to 50 N-m {5.1 kgf-m, 37 ft-lbf}.
Stage 2: Tighten to 80 N-m {8.16 kgf-m, 59 ft-lbf}.
Stage 3: Tighten to 112 N-m {11.42 kgf-m, 83 ft-lbf}.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.