Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 83 (DTC INDEX - HYBRID)SUSPENSIONTIRE PRESSURE MONITORING SYSTEM (TPMS) DTCS
2008 Mazda Tribute s Sport, 4WD
Tire Pressure Monitoring System (TPMS) DTCS
2008 Mazda Tribute s Sport, 4WDSECTION Tire Pressure Monitoring System (TPMS) DTCS
WARNING: This page is about a different variant/trim than selected.
TIRE PRESSURE MONITORING SYSTEM (TPMS) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B106A | Pressure Sensor Range Bit Incorrect State | See PINPOINT TEST 4: DTC B106B - TIRE PRESSURE SENSOR LOW BATTERY . |
| B2477 | Module Configuration Failure/Mismatch | DTC B2477 is only present when a new SJB is installed, the SJB is incorrectly flashed or the SJB is incorrectly configured. Successfully configuring the SJB is the only way to clear this DTC. Make sure the SJB is configured correctly. If DTC B2477 is still present, see DIAGNOSTIC TROUBLE CODE (DTC) CHART - B, C AND U CODES . |
| B2868 | Left Front Tire Pressure Sensor Fault | DTC B2868 is only present when a new SJB is installed, the SJB is flashed or the SJB is reconfigured. TRAIN the tire pressure sensors. See TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING . |
| B2869 | Right Front Tire Pressure Sensor Fault | DTC B2869 is only present when a new SJB is installed, the SJB is flashed or the SJB is reconfigured. TRAIN the tire pressure sensors. See TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING . |
| B2870 | Right Rear Tire Pressure Sensor Fault | DTC B2870 is only present when a new SJB is installed, the SJB is flashed or the SJB is reconfigured. TRAIN the tire pressure sensors. See TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING . |
| B2871 | Left Rear Tire Pressure Sensor Fault | DTC B2871 is only present when a new SJB is installed, the SJB is flashed or the SJB is reconfigured. TRAIN the tire pressure sensors. See TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING . |
| B2872 | Tire Pressure Sensor Fault |
NOTE:
If the vehicle has been stationary for more than 30 minutes, the sensors will go into a "sleep mode" to conserve battery power. It will be necessary to wake them up so they will transmit the latest tire pressure information to the SJB. ACTIVATE the TPMS sensors. See TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR ACTIVATION
. |
| B287A | Tire Pressure System Fault | See PINPOINT TEST 3: TPMS INDICATOR FLASHES FOR 70 SECONDS AND THEN REMAINS ON SOLID WHEN THE IGNITION KEY IS TURNED TO THE ON POSITION AND DTC B2872 OR B287A IS PRESENT . |
| C2780 | ECU in Manufacturing Mode | DTC C2780 is only present when a new SJB is installed, the SJB is flashed or the SJB is reconfigured. TRAIN the tire pressure sensors. See TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR TRAINING . |
| U0155 | Lost Communication with Instrument Cluster | See PINPOINT TEST 4: THE INSTRUMENT CLUSTER (IC) DOES NOT RESPOND TO THE SCAN TOOL to diagnose the no communication problem. |
| All other SJB DTCs | - | See COMMUNICATIONS NETWORK . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.