Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 66 (SECURITY SYSTEM AND LOCKS SYSTEM - HYBRID)FRONT DOOR HANDLES, LOCKS AND LATCHES - EXPLODED VIEW
2008 Mazda Tribute s Sport, 4WD
Front Door Handles, Locks And Latches - Exploded View
2008 Mazda Tribute s Sport, 4WDSECTION Front Door Handles, Locks And Latches - Exploded View
WARNING: This page is about a different variant/trim than selected.
FRONT DOOR HANDLES REFERENCE CHART
| 1 | Front door latch bolts (3 required) |
| 2 | Exterior front door handle seal, front |
| 3 | Exterior front door handle cover |
| 4 | Exterior front door handle |
| 5 | Exterior front door handle seal, rear |
| 6 | Interior door handle |
| 7 | Interior door handle screw |
| 8 | Exterior door handle reinforcement |
| 9 | Exterior door handle reinforcement screw |
| 10 | Exterior front door handle cover retaining screw |
| 11 | Interior door handle actuating cable |
| 12 | Door lock actuating rod |
| 13 | Front door latch |
| 14 | Exterior door handle actuating rod |
| 15 | Door lock cylinder actuating rod |
| 16 | Door lock cylinder |
| 17 | Door striker bolts (2 required) |
| 18 | Door striker |
- For additional information, see the appropriate procedures .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.