SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 61 (LIGHTING SYSTEM - HYBRID)STEERING COLUMN MULTIFUNCTION SWITCH REMOVAL/INSTALLATION
2008 Mazda Tribute s Sport, 4WD

Steering Column MULTIFUNCTION Switch Removal/Installation

2008 Mazda Tribute s Sport, 4WDSECTION Steering Column MULTIFUNCTION Switch Removal/Installation
WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Steering Column Multifunction Switch Components
G06361489Courtesy of MAZDA MOTORS CORP.
ITEM DESCRIPTION CHART

1 Steering column opening trim panel
2 Upper steering column shroud
3 Lower steering column shroud
4 Lower steering column shroud screws (3 required)
5 Multifunction switch electrical connector
6 Multifunction switch
7 Multifunction switch screws
  1. Remove the steering column opening trim panel.
  2. Remove the 3 lower steering column shroud screws.
  3. Remove the upper and lower steering column shrouds.
  4. Remove the 2 multifunction switch screws.
  5. Disconnect the multifunction switch electrical connector and remove the switch.
  6. To install, reverse the removal procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.