Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 61 (LIGHTING SYSTEM - HYBRID)REAR LAMP ASSEMBLY REMOVAL/INSTALLATION
2008 Mazda Tribute s Sport, 4WD
Rear Lamp Assembly Removal/Installation
2008 Mazda Tribute s Sport, 4WDSECTION Rear Lamp Assembly Removal/Installation
WARNING: This page is about a different variant/trim than selected.
- Remove the rear lamp assembly.
- Remove the bolts.
- Using a flat tipped screwdriver covered with a rag, gently pry the lamp from the edge of the quarter panel at the bottom portion, and then the top portion.
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.