SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 61 (LIGHTING SYSTEM - HYBRID)FOG LAMP REMOVAL/INSTALLATION
2008 Mazda Tribute s Sport, 4WD

Fog Lamp Removal/Installation

2008 Mazda Tribute s Sport, 4WDSECTION Fog Lamp Removal/Installation
WARNING: This page is about a different variant/trim than selected.
Fig 1: Fog Lamp Replacement Components With Torque Specifications
G06361478Courtesy of MAZDA MOTORS CORP.
ITEM DESCRIPTION CHART

1 Fender splash shield bolts (4 required)
2 Fender splash shield pin-type retainers (4 required)
3 Fender splash shield
4 Fog lamp electrical connector
5 Fog lamp
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
  1. With the vehicle in NEUTRAL, see LIFTING .
  2. Remove the 4 fender splash shield bolts.
    • To install, tighten to 5 N.m {0.5 kgf.m, 44 in.lbf}.
  3. Remove the 4 fender splash shield pin-type retainers.
    • Position the fender splash shield aside.
  4. Disconnect the fog lamp bulb electrical connector.
  5. Release the 3 retainers and remove the fog lamp.
  6. To install, reverse the removal procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.