Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 10 (GENERAL INFORMATION - HYBRID)UNITSNOTES
2008 Mazda Tribute s Sport, 4WD
Section 10 (General Information - Hybrid): Units: Notes
2008 Mazda Tribute s Sport, 4WDSECTION Notes
WARNING: This page is about a different variant/trim than selected.
UNITS REFERENCE
| Electrical current | A (ampere) |
| Electric potential | V (volt) |
| Electric power | W (watt) |
| Length | mm (millimeter) |
| in (inch) | |
| Negative pressure | kPa (kilopascal) |
| mm-Hg (millimeters of mercury) | |
| in-Hg (inches of mercury) | |
| Positive Pressure | kPa (kilopascal) |
| kgf/cm2 (kilogram force per square centimeter) | |
| psi (pounds per square inch) | |
| Resistance | I%0 (ohm) |
| Torque | N.m (Newton meter) |
| kgf.m (kilogram force per meter) | |
| kgf.cm (kilogram force per centimeter) | |
| ft.lbf (foot-pound force) | |
| in.lbf (inch-pound force) | |
| Volume | L (liter) |
| US qt (U.S. quart) | |
| Imp qt (Imperial quart) | |
| ml (milliliter) | |
| cc (cubic centimeter) | |
| cu in (cubic inch) | |
| fl oz (fluid ounce) | |
| Weight | g (gram) |
| oz (ounce) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.