Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 936 (COMPONENT TESTING)COMPONENT TESTINGEXTERIOR REAR VIEW MIRROR SWITCH (17B676)COMPONENT TESTING PROCEDURE
2008 Mazda Tribute s Sport, 4WD
Component Testing Procedure
2008 Mazda Tribute s Sport, 4WDSECTION Component Testing Procedure
WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
EXTERIOR REAR VIEW MIRROR SWITCH (17B676) COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Left mirror | Selector switch Left | ||
| Up | 1 and 7 6 and 5 |
Up | Closed circuit |
| Down | 1 and 6 7 and 5 |
Down | Closed circuit |
| Left | 1 and 4 6 and 5 |
Left | Closed circuit |
| Right | 1 and 6 4 and 5 |
Right | Closed circuit |
| Right mirror | Selector switch Right | ||
| Up | 1 and 8 6 and 5 |
Up | Closed circuit |
| Down | 1 and 6 8 and 5 |
Down | Closed circuit |
| Left | 1 and 3 6 and 5 |
Left | Closed circuit |
| Right | 1 and 6 3 and 5 |
Right | Closed circuit |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.