Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 803 (SEATS)SEAT CONTROL SWITCHREMOVAL AND INSTALLATION

2008 Mazda Tribute s Sport, 4WD

Removal and Installation

2008 Mazda Tribute s Sport, 4WDSECTION Removal and Installation

WARNING: This page is about a different car, the 2006 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If a side air bag deployment took place, a new seatback pad, trim cover, and side air bag module must be installed. A new seatback frame should be installed if necessary.

Depower the SRS. See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .

Fig 1: Removing Seat Control Switch Knob
Courtesy of MAZDA MOTORS CORP.
Remove the seat control switch knob.

Fig 2: Removing Front Seat Cushion Side Shield
Courtesy of MAZDA MOTORS CORP.
Remove the front seat cushion side shield.
1. Remove the seat backrest handle.
2. Remove the screw.
3. Disconnect the electrical connector(s) and remove the shield.
  
  Fig 3: Removing Seat Control Switch
  Courtesy of MAZDA MOTORS CORP.
Remove the seat control switch.
1. Remove the screws.
2. Remove the switch.
To install, reverse the removal procedure.
Repower the SRS. See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.