Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 786 (CRUISE CONTROL SYSTEM)SPEED CONTROL ACTUATORINSTALLATION

2008 Mazda Tribute s Sport, 4WD

Speed Control Actuator: Installation

2008 Mazda Tribute s Sport, 4WDSECTION Installation

WARNING: This page is about a different car, the 2006 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Bolts And Cruise Control Actuator Bracket With Torque Specifications

Courtesy of MAZDA MOTORS CORP.

Attach the cruise control actuator to the bracket.

Fig 2: Installing Cruise Control Actuator Assembly With Torque Specifications
Courtesy of MAZDA MOTORS CORP.
Install the cruise control actuator assembly.
1. Install the nuts.
2. Secure the wire harness to the bracket.
3. Connect the electrical connector.
  
  Fig 3: Inserting Cruise Control Cable
  Courtesy of MAZDA MOTORS CORP.
Insert the cruise control cable slug into the cruise control actuator pulley slot.
1. Gently push the retaining spring.
2. Insert the cruise control cable slug completely into the cruise control actuator pulley slot.
  
  Fig 4: Aligning Cruise Control Cable Cap Tabs
  Courtesy of MAZDA MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.