Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 785 (POWER STEERING SYSTEM)IGNITION SWITCHREMOVAL AND INSTALLATION

2008 Mazda Tribute s Sport, 4WD

Removal and Installation

2008 Mazda Tribute s Sport, 4WDSECTION Removal and Installation

WARNING: This page is about a different car, the 2006 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column can result.

Depower the supplemental restraint system (SRS). See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
Remove the instrument panel steering column cover.
Remove the 3 lower steering column cover mounting screws.
Remove the lower steering column cover.
Remove the upper steering column cover.

Fig 1: Disconnecting Ignition Switch Electrical Connector
Courtesy of MAZDA MOTORS CORP.
Disconnect the ignition switch electrical connector.
NOTE:
- Lower the steering column to the lowest tilt position.
Remove the ignition switch by pressing the 2 tabs and pulling the ignition switch outward.
To install, reverse the removal procedure.
- Repower the supplemental restraint system (SRS). See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.