Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2008TRIBUTE S SPORT, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 765 (ENGINE CONTROL SYSTEM)THROTTLE POSITION (TP) SENSOR - 2.3LREMOVAL AND INSTALLATION
2008 Mazda Tribute s Sport, 4WD
Removal and Installation
2008 Mazda Tribute s Sport, 4WDSECTION Removal and Installation
WARNING: This page is about a different car, the 2006 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable. See BATTERY DISCONNECT .
- Disconnect the throttle position (TP) sensor electrical connector.
- Remove the two screws and the TP sensor.CAUTION:
- Be sure to hand start the TP sensor screws. These are self-threading screws. Failure to hand start them can cause damage to the throttle body.
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.